ZHANGJIAGANG HENGYANG METALLURGY TECHNOLOGY CO.,LTD
ZHANGJIAGANG HENGYANG METALLURGY TECHNOLOGY CO.,LTD
Add to Cart
Silicone Rubber Heater Pad With Sensor For 3D Printer
Advantage:
3D Printer Heater Details
| Supply voltage: | 0-400V,Please contact us for other voltages. |
| Insulation Material: | Silicone Rubber Coated Fiberglass |
| Max.Operating Temperature: | 260 Deg C or 500 Deg F |
| Max.Power Density: | 5w/sq.cm depending on application |
| Heating Elements | Wire Wound or Etched Foil.Please contact |
| Resistance Tolerance: | about +/- 5% |
| Thickness: | 1.5mm |
| Flammability: | Flame retardant |
| Thermal Protection: | On board thermal fuse,thermostat,thermistor and PT100 are available as part of your thermal management solution. |
| Power Leads: |
High temperature PTFE or Silicone insulation leads |
3D Printer Heater Temperature controller
* Surface Sensing Thermostats
* Adjustable Thermostats dial or digital
* Thermocouples (K, J or PT100 etc)
* Thermistor
* Thermal Protector
3D Printer Heater Features
1. Thinness, lightness, sticky and flexibility
2. Improve heat transfer, accelerate warming and decrease power under the process of operation
3. Heat fast and high thermal conversion efficiency
Performance Capabilities for Blanket Heater
1. Operating temperatures up to 430°F (220°C)
2. Watt densities up to 0.1W/cm 2,dependent upon application temperature
3. Wire-wound element thickness - 0.055 in. (1.5 mm)
4. Etched foil element - 0.022 in. (0.56 mm)
5. Waterproof and non-toxic(Waterproof grad:IP68)